Designed to equally cool two beer towers at the same time!

Several customers asked if the output of our beer tower cooler could be adapted to support 2 beer towers. We tried adding a tee to the line and got very little airflow out of both hoses. The issue is that our single tower cooler is designed to push just enough air to cool one beer tower, not two, and the tee splits this air flow into almost nothing. But through some experimenting we discovered that we could push the same low volume through two separate hoses that we push through the our single hose tower cooler as long as both hoses are plumbed directly into the box.

And the best part is that our new 2 tower cooler only costs $10.00 more than our single tower cooler!

Our tower cooler 2 features:

Cools 2 beer towers at the same time
Works with any kegerator - home built or store bought.
Less expensive than buying two single beer tower coolers.
Works with homebrew or draft beer kegerators.
Easy to install - just plug in and you are ready to go.
Uses a tiny 40 mm fan to blow just the right amount of air into both beer towers.
Includes two three foot sections of 1" OD hose to push the cold air up into the beer towers, leaving plenty of room for warmer air to fall back down into the kegerator.
Note: To keep airflow balanced, if you cut any length off one hose you must cut the same length off the other hose
Includes a energy star energy efficient power supply.
Power supply can be unplugged - can be run under the kegerator door gasket or through a hole you carefully drill through your kegerator wall.
Uses less power than a 15 watt night light.
Our beer tower cooler includes everything - no tools need unless you want to (carefully) drill a hole through the side or back of your kegerator tor the power supply cord.

Install is simple with no tools needed:

Unpack the beer tower cooler.
Push the open end of the cooler hoses into into your beer towers until they stop.
Use the supplied nylon zip-ties to tie the hoses to your beer lines.
Plug the power supply into a wall outlet or extension cord.
Run the thin power cable past the kegerator door and plug into the Beer Tower Cooler.
For a cleaner looking install, you may want to run the power cord through a small hole you drill through the side or back of your kegerator. Be careful to avoid refrigerant lines if you decide to do this.

Note: A beer tower cooler will not solve other issues with your kegerator like incorrect CO2 pressure, short beer line, warm keg or beer faucet / tower cleanliness issues. Your kegerator is a beer delivery system and this tower cooler, like any other, is designed to address one nagging problem. If you install our beer tower cooler or anyone else's or you build & install your own and still have a foaming problem, you have another cause not related to the beer tower getting warm. But once you solve that foaming issue, the problem this beer tower cooler was designed to solve - the issue where the beer tower and beer shanks stay warm - will also be solved.

Just $49.95 for a complete 2 Tower Beer Tower Cooler.

USA Customers - Buy your Beer Tower Cooler directly from this web site and receive free Priority Mail shipping - up to a $9 value depending on where you are at the country.