Our original Beer Tower Cooler with on/off switch and power on light.

This tower cooler is the upgraded version of our original tower cooler. We found out that several customers were plugging our tower cooler into a plug strip so that they can turn the cooler off at night. We just went one step further and added a power switch and LED power light directly to the tower cooler.

The number one complaint about any beer tower based kegerator is that the beer faucet & shank get warm and your first 1/2 glass of beer is always foamy. But the solution is less than 5 minutes away - just install our tower cooler. Our tower cooler works by continuously blowing a small volume of cold air into your beer tower and the cold air keeps your beer shanks and faucets ice cold. A side benefit is that the continuous cold keeps faucet mold and bacteria growth at an absolute minimum.

Our tower cooler features:

Works with any kegerator - home built or store bought.
Works with homebrew or draft beer.
Easy to install - just plug in and you are ready to go.
Uses a tiny 40 mm fan to blow just the right amount of air into your beer tower.
Includes three foot of 1" OD hose to push the cold air up into the beer tower, leaving plenty of room for warmer air to fall back down into the kegerator.
Includes a energy star energy efficient power supply.
Power supply can be unplugged - can be run under the kegerator door gasket or through a hole you carefully drill through your kegerator wall.
Uses less power than a 15 watt night light.
Our beer tower cooler includes everything - no tools need unless you want to (carefully) drill a hole through the side or back of your kegerator tor the power supply cord.
Power on/off toggle switch
Power on LED indicator - generates no heat inside your kegerator

Install is simple with no tools needed:

Unpack the beer tower cooler.
Push the open end of the cooler hose up into your beer tower until it stops.
Use the supplied nylon zip-tie to tie the hose to your beer lines.
Plug the power supply into a wall outlet or extension cord.
Run the thin power cable past the kegerator door and plug into the Beer Tower Cooler.
For a cleaner looking install, you may want to run the power cord through a small hole you drill through the side or back of your kegerator. Be careful to avoid refrigerant lines if you decide to do this.

Note: A beer tower cooler will not solve other issues with your kegerator like incorrect CO2 pressure, short beer line, warm keg or beer faucet / tower cleanliness issues. Your kegerator is a beer delivery system and this tower cooler, like any other, is designed to address one nagging problem. If you install our beer tower cooler or anyone else's or you build & install your own and still have a foaming problam, you have another cause not related to the beer tower getting warm. But once you solve that foaming issue, the problem this beer tower cooler was designed to solve - the issue where the beer tower and beer shank stay warm - will also be solved.

Just $54.95 for a complete Beer Tower Cooler.

USA Customers - Buy your Beer Tower Cooler directly from this web site and receive free Priority Mail shipping - up to a $9 value depending on where you are at in the country.